AEG ARCTIS Operating Instructions Manual - Page 11

Print Page

Installation

Electrical Connection

The plug socket necessary for connection of your appliance to the

electricity supply should be positioned so that it is possible to pull out

the appliance plug.

If your appliance is installed under a

continuous worktop, the plug socket

should be provided as shown.

Alternatively a concealed spur socket

fitted with a 13 A fuse may be fitted.

If the socket is not accessible once

the appliance is built in, the electrical

installation must include suitable

means of isolating the appliance from

the mains (e.g. fuse, cut-out, current

trip or similar with a minimum con-

tact separation of 3 mm).

Before initial start-up, refer to the appliance serial plate to ascertain if

supply voltage and current values correspond with those of the mains

at the installation location.

e.g.: AC 220 ... 240 V

(i.e. 220 to 240 volts alternating current, 50 Hertz).

The rating plate is inside the appliance on the left.

220 ... 240 V

AEG44

50 Hz or

~50 Hz

130

300