Fujitsu FTP-639MCL354 Product Specification - Page 10
Browse online or download pdf Product Specification for Printer Fujitsu FTP-639MCL354. Fujitsu FTP-639MCL354 26 pages.
Print PageItem
For printing
For logic
Motor drive
Operating
temperature and
humidity *1
Temperature and
humidity in storage
Noise
Vibration
(non-operation)
Inpact
(non-operation)
Package drop
Temperature &
humidity cycling
(non-operation)
Electric life
Wear life
Platen release life
Photo interpreter
life
Printing start position on
the left edge
*1: The Print density guarantee is +5~+40 C. Refer to the figure below for the relation
of the temperature and humidity.(The range is in fat line)
*2: After the test, it shall satisfy the printing specification.
85
Date
Design
Inspection
Rev.
Design
V oltage: DC 24V±5%,Printing speed:200mm/s
Peak current: 4.0A (at 25℃, Rav=800Ω, ２ ４V , printing black ratio 25%)
V oltage: DC 5V±５%
Current: 0.2 Ａ Max.
V oltage: DC 24V±5%
Current: 1.0 A Max. (by the F&T standard constant-current drive circuit)
0℃〜+50℃, 20〜85％RH. No dew should be allowed.
-20℃〜60℃, 5〜95％RH. No dew should be allowed. Yet, the paper is not
included.
Should not exceed 60dB at a point 1 m above from the printing mechanism
position level.
10〜55〜10Hz. Amplitude is 0.15mm. An １ octave/min, １G Max. 20 cycle
each to X, Y, and Z directions.
50Ｇ, 11ｍ/ ｓ , half-sine wave, 5 times each to X, Y and Z direction
75 cm of 6 faces, 75 cm of corners and ridges as it is packed.
2 continuous cycles as a unit cycles: -25℃ （2H ）〜room temp. （2H ）〜65℃,
10％RH (2H ）〜room temp.
1 hundred-million pulses (under our standard printing conditions.)
Paper feed length, 100 km (printing rate 12.5% max.)
More than 5000 times (regarding opening and closing as one time.)
４
1.2×10
hours (electrified time) with the recommended circuit.
5.25±1.5mm (by paper width 82 mm) from the paper edge to the left printing
However, ① １PLY, when the specified paper for long-term record
edge.
storage is used.② When no paper jam or no paper empty is present.
Changes made
Inspect.
Specifications
(%RH)
45
20
7
0
FTP-639MCL354 SPECIFICATION
A1NA02273-0354
FUJITSU COMPONENT LIMITED
Approv.
40
50(℃)
Submit to
10 26