3.4. Scanning with the Carrier Sheet
If you use the Carrier Sheet, you can scan large documents
such as A3 and B4 size documents, and documents of
irregular shapes such as clippings of newspaper.
3.4.1. Creating Facing Pages in One Image
Fold the document in half, scan it in duplex scanning mode,
and then merge both front and back side images to make a
double-page spread image.
When you scan with the Carrier Sheet, a detection
error likely occurs in the folded portion, which may lose
part of the page image. Therefore, this function is not
recommended for scanning where accuracy is critical.
Here, as an example, this section explains how to scan an
A3-size document.
If you are scanning an A3 document, it is not possible to
load it onto the scanner as it is. Fold the document in half
and scan it following the procedure below.
1.
Spread the page to be scanned facing outwards and
fold it in half from the center.
Fold it tightly and smooth out the crease so that the
folded portion does not appear puffed.
2.
Open the Carrier Sheet and place the folded
document inside.
Align the fold with the right
edge of the Carrier Sheet
so that the document fits
into the Carrier Sheet at
the upper corner.
3.
Load the Carrier Sheet onto the ScanSnap.
● Load the Carrier Sheet
with the portion striped in
black and white as the
leading edge as shown in
the right figure.
● When the Carrier Sheet is
used for scanning,
continuous scanning is not
possible. Scan one piece
or one sheet at one time.
14
4.
Press the [SCAN] button.
The front and back
images are merged into
a double-page spread
image.
The loading method and ScanSnap Manager's
HINT
settings differ according to the documents to be
scanned. Refer to "ScanSnap S510
Operator's Guide" on the "ScanSnap Setup
CD-ROM" for details.
3.4.2. Scanning irregular-shaped Documents
This section explains how to scan documents that are
difficult to scan as it is.
1.
Right-click the ScanSnap Manager icon
taskbar and select [SCAN Button Settings].
The "ScanSnap Manager - Scan and Save Settings"
dialog box appears.
2.
On the [Paper size] tab, click the
Settings...
button.
"
The "Carrier Sheet Settings" dialog box appears.
3.
On the "Carrier Sheet Settings" window, select
"Create front and back images separately" in the
"Mode" drop-down list, and then click the [OK]
button.
4.
Open the Carrier Sheet and place the document
inside.
Neatly align the top of the
material with the top of the
Carrier Sheet. Center the
material so that it is
entirely contained in the
Carrier Sheet.
on the
S
Carrier Sheet
"
Print Page