Fujitsu SK-96320-80PMC User Manual - Page 18

Browse online or download pdf User Manual for Motherboard Fujitsu SK-96320-80PMC. Fujitsu SK-96320-80PMC 34 pages.
Also for Fujitsu SK-96320-80PMC: User Manual (34 pages), User Manual (34 pages)

Print Page

3.8 LIN"B" (JP: 9, 10, 38, 39, 45)

One LIN-transceiver (U4, X6) can be connected to one of the microcontroller's UART

interfaces.

JP9

enable LIN-Transceiver

JP10

LIN Master-mode

JP38, JP39 connects UART 1 to the LIN-transceiver (U4, X6)

If the LIN interface is not used then the jumpers should be left open.

Jumper

JP9 (LIN enable)

JP10 (LIN Master)

JP38 (LIN"B"RXD)

JP39 (LIN"B"TXD)

JP45

(VBAT_B)

JP42 (WAKE)

By default, the LIN"B"-interface is not connected to a UART.

3.9 CAN"A" (JP: 19, 25, 26)

One high-speed CAN-transceiver can be connected to the microcontroller's CAN interface.

JP25, JP26 connects a CAN-port to the CAN-transceiver (U7, X10).

If the CAN interface is not used then the jumpers should be left open.

JP19

selects the power supply of the CAN A transceiver (5V / 3V3)

Jumper

JP25 (CAN"A"TX)

JP26 (CAN"A"RX)

JP19 (VCC CAN A)

FMEMCU-UG-960010-11

SK-96320-80PMC User Guide

Chapter 3 Jumpers and Switches

Setting

Description

Closed

LIN-transceiver is enabled

Open

LIN-transceiver is disabled

Closed

LIN Master-mode

Open

LIN Slave-mode

Closed

SIN8 of the MCU is connected to LIN"B"

Open

SIN8 of the MCU is not connected to LIN"B"

Closed

SOT8 of the MCU is connected to LIN"B"

Open

SOT8 of the MCU is not connected to LIN"B"

Closed

Vs of LIN B is powered by the board

Open

No voltage supply to Vs of LIN B

1-2

Connects WAKE signal to Bus power

2-3

Connects WAKE signal to VCC

Setting

Description

closed

TX1 of MCU is connected to CAN"A"

closed

RX1 of MCU is connected to CAN"A"

1-2

CAN A VCC is set to 5V

2-3

CAN A VCC is set to 3V3

- 18 -