Fujitsu SK-96320-80PMC User Manual - Page 25

Browse online or download pdf User Manual for Motherboard Fujitsu SK-96320-80PMC. Fujitsu SK-96320-80PMC 34 pages.
Also for Fujitsu SK-96320-80PMC: User Manual (34 pages), User Manual (34 pages)

Print Page

5 Connectors

5.1 Power connector (X12)

The following figure shows the power connection jack X12. This connector is used to

connect an external unregulated DC power supply voltage (9V-12V DC) to the evaluation

board.

Connector X12:

It is recommended to use 9V DC input to minimize the power dissipation of the voltage

regulators.

5.2 Edge connector (X1, X2)

All pins (except oscillator Pins) of the microcontroller are directly connected to X1 and X2 as

follows:

Connector

X1 (1 – 40)

X2 (41 – 80)

The odd pin numbers are located on the one side and the even pin numbers are located on

the other side of the connector.

5.3 UART"A", UART"B" connector (X3, X5)

Two 9-pin D-Sub female connectors are used

for the serial interface UART"A" and UART"B".

TXD is the transmit output, RXD is the receive input.

The DTR or RTS signal can be used to generate a reset.

Please use a 1:1 cable for PC-connection.

SK-96320-80PMC User Guide

Chapter 5 Connectors

Shield is connected to positive voltage supply

Center is connected to ground (GND)

MCU Pins

1 – 40

41 – 80

Connectors X3, X5:

- 25 -

GND DTR RxD TxD

CTS RTS DSR

FMEMCU-UG-960010-12