Indesit WIXXL 127 Instructions For Use Manual - Page 2

Browse online or download pdf Instructions For Use Manual for Washer Indesit WIXXL 127. Indesit WIXXL 127 36 pages.

Print Page

Indesit WIXXL 127 Instructions For Use Manual

Installation

Keep this instruction manual in a safe place for

future reference. Should the appliance be sold,

transferred or moved, make sure the instruction

manual accompanies the washing machine to inform

the new owner as to its operation and features.

Read these instructions carefully: they contain vital

information on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has been

damaged during transport. If this is the case, do not

install it and contact your retailer.

Remove the transit fixings

IMPORTANT: Follow these instructions to remove the

TWO transit fixings (see Description for location).

Situated on either side of the rear panel, BOTH

transit bolts MUST be r removed emoved befor

before e use use.

Failure to do so may cause damage to your machine.

BOTH

1. Remove the 2

protective screws and

the rubber washer with

the respective spacer,

situated on the rear of

the appliance (see figure).

2. Unscrew the bolt

using a 13mm spanner.

STOP when 3 threads

can be seen.

3. Hold, slide sideways

and pull to remove.

4. For safety, insert one of the the plastic covers

(supplied with your machine) over the hole.

Repeat steps 1 to 4 to remove the second transit bolt.

Packaging materials are not children's toys.

Levelling

Your machine will be noisy if the two front feet are

not adjusted so that the machine stands firm and

level.

1. Install the washing machine on a flat sturdy floor,

without resting it up against walls, furniture

cabinets or other.

Levelling your appliance correctly will provide it with

stability and avoid any vibrations, noise and shifting

during operation. If it is placed on a fitted or loose

carpet, adjust the feet in such a way as to allow

enough room for ventilation beneath the washing

machine.

Electric and water connections

Connecting the water inlet hose

3. Make sure there are no kinks or bends in the hose.

The water pressure at the tap must be within the

v a l u e s i n d i c a t e d i n t h e Te c h n i c a l d e t a i l s t a b l e

(on the next page).

2. If the floor is not

perfectly level, compen-

sate for any unevenness

by tightening or

loosening the adjustable

front feet (see figure); the

angle of inclination,

measured according to

the worktop, must not

exceed 2°.

1. Insert seal A into the end

of the inlet hose and screw

the latter onto a cold water

tap with a 3/4 gas threaded

mouth (see figure).

Before making the

connection, allow the

water to run freely until it

is perfectly clear.

2. Connect the other

end of the water inlet

hose to the washing

machine, screwing it

onto the appliance's

cold water inlet, situated

on the top right-hand

side on the rear of the

appliance (see figure).