Indesit WIXXL 127 Інструкція з використання Посібник з використання - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з використання Посібник з використання для Пральна машина Indesit WIXXL 127. Indesit WIXXL 127 36 сторінок.
Друкувати сторінку
Installation
!
Keep this instruction manual in a safe place for
GB
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.
!
Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washing machine.
2. Check whether the washing machine has been
damaged during transport. If this is the case, do not
install it and contact your retailer.
Remove the transit fixings
IMPORTANT: Follow these instructions to remove the
TWO transit fixings (see Description for location).
Situated on either side of the rear panel, BOTH
transit bolts MUST be r removed emoved befor
transit bolts MUST be r removed emoved befor
transit bolts MUST be r removed emoved befor
transit bolts MUST be r removed emoved befor
transit bolts MUST be r removed emoved befor
before e use use.
before e use use.
before e use use.
before e use use.
before e use use.
!
Failure to do so may cause damage to your machine.
2
BOTH
BOTH
BOTH
BOTH
1. Remove the 2
protective screws and
the rubber washer with
the respective spacer,
situated on the rear of
the appliance (see figure).
2. Unscrew the bolt
using a 13mm spanner.
STOP when 3 threads
can be seen.
3. Hold, slide sideways
and pull to remove.
4. For safety, insert one of the the plastic covers
(supplied with your machine) over the hole.
!
Repeat steps 1 to 4 to remove the second transit bolt.
!
Packaging materials are not children's toys.
Levelling
Your machine will be noisy if the two front feet are
not adjusted so that the machine stands firm and
level.
1. Install the washing machine on a flat sturdy floor,
without resting it up against walls, furniture
cabinets or other.
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washing
machine.
Electric and water connections
Connecting the water inlet hose
A
3. Make sure there are no kinks or bends in the hose.
!
The water pressure at the tap must be within the
v a l u e s i n d i c a t e d i n t h e Te c h n i c a l d e t a i l s t a b l e
(on the next page).
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or
loosening the adjustable
front feet (see figure); the
angle of inclination,
measured according to
the worktop, must not
exceed 2°.
1. Insert seal A into the end
of the inlet hose and screw
the latter onto a cold water
tap with a 3/4 gas threaded
mouth (see figure).
Before making the
connection, allow the
water to run freely until it
is perfectly clear.
2. Connect the other
end of the water inlet
hose to the washing
machine, screwing it
onto the appliance's
cold water inlet, situated
on the top right-hand
side on the rear of the
appliance (see figure).