AEG 9600 D Operating And Installation Manual - Page 14

Browse online or download pdf Operating And Installation Manual for Ventilation Hood AEG 9600 D. AEG 9600 D 16 pages. Cooker hood

Print Page

Mounting – Figure 7

• Place the outline (1) on the angle above the cooker hood.

• As demonstrated, drill the hole and insert four screw anchors and

four screws (2). Do not screw in the screws completely, because

they act as a hook for the cooker hood.

• Prepare the electrical connections and realize a perforation on the

wall where the cooker hood is required to be mounted in the external

air discharge version.

• Remove the telescopic structure A from the four screws (3), use a

pencil to mark two perforation for the safety screws, remove the

telescopic structure again A, drill both perforations and insert both

the screw anchors (4).

• Adjust the telescopic structure: the three components render

possible a lengthening between 80 and 100 cm (A). When both

upper components (B) are divided in the same way, the structure

may be lengthened between 100 and 120 cm (between 100 and

100.5 cm in the model with the tube).

Only for extractor version

• Fix the deviation plate F for the air circulation with four screws (2 x 2)

on the upper part of the structure A and secure it with a tubing of

suitable length (5) to the cooker hood's discharge.

Only for the filter version

• Ensure that the tube is long enough at the connection ring above the

cooker hood (5).

After selecting the preferred installation, proceed in the

following manner:

• Suspend the box (ensuring that the electrical connection box is on

the side where the command components are to be located) and

screw in the four screws (6). Introduce and screw in both the safety

screws (7).

• Carry out the electrical connection (8).

• Introduce the chimney cap and fix it to the box with two screws (9),

and leave the lower part of the tab momentarily hanging downwards

(10).

• Suspend the cooker hood covering in the box and affix the provided

nut screws (11). Screw in the four screws (10).

• Connect the motor (13a) and the lights (13b), move the lower side of

the chimney cap and fix it to the cooker hood using two screws (14).