AEG protect d. 2000 Installation And Operating Instructions Manual - Page 5

Browse online or download pdf Installation And Operating Instructions Manual for Ventilation Hood AEG protect d. 2000. AEG protect d. 2000 25 pages. Fume extractor hood

Print Page

Electrical connections

Safety warnings for electrician

Check that the power supply voltage shown on the rating

plate corresponds to the mains supply before proceeding

to make any electrical connections. If the unit is supplied

ready-fitted with a plug, it can be connected to any easily

accessible socket installed in compliance with the

regulations in force.

If a fixed connection is required, the hood must be

installed exclusively by an electrician registered with the

local electrical company. The hood should be installed

using an omnipolar switch with contacts that open to at

least 3 mm.

Fused switches can be used for this purpose (with

cartridge fuses that can be extracted from the fuse

holder), as can automatic circuit breakers and contactors

which open to more than 3 mm.

We decline all responsibility for any problems or faults

caused by a failure to observe the above instructions.

If the power socket is positioned directly above the

extractor hood or on the chimney cover this will give two

advantages:

1. The socket cannot be seen.

2. The unit can be disconnected whenever required by

simply taking out the plug.

Electrical connections

220-230 V - using fixed power supply line with plug.

(The unit should only be connected up by an authorized

electrician).