Kohler Archer K-1124-RA-0 Homeowner's Manual - Page 4

Browse online or download pdf Homeowner's Manual for Bathtubs Kohler Archer K-1124-RA-0. Kohler Archer K-1124-RA-0 24 pages. Bath whirlpools

Print Page

Turn the jet trim ring

clockwise to

decrease the flow.

Turn the jet trim ring counterclockwise

to increase the flow.

Operating Your Whirlpool

Operation

Position the jet nozzles to face down toward the basin. Turn the jet trim rings fully

counterclockwise.

NOTE: The water temperature in the whirlpool should never exceed 104°F (40°C).

Close the drain, then ﬁll the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.

Use your hand to test the water temperature for comfort and safety, then carefully enter the

whirlpool.

Press the air switch to turn on the pump to the whirlpool.

NOTE: If equipped, the heater will also turn on.

Adjust the jets for optimum air/water mixture. Turn the jet trim rings clockwise to reduce the ﬂow

or counterclockwise to increase the ﬂow. Position the jet nozzles to direct the water ﬂow as desired

to maximize your hydro-massage experience.

Press the air switch a second time to turn off the pump the whirlpool.

Carefully exit the whirlpool, then open the drain to empty the water from whirlpool.

NOTE: If the whirlpool does not function properly, please refer to the "Troubleshooting" section.

For best results, keep the following in mind when caring for your KOHLER product:

• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and

dry any overspray that lands on nearby surfaces.

• Do not allow cleaners to soak on surfaces.

• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring

pad to clean surfaces.

For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &

Cleaning information, call 1-800-456-4537.

1421656-5-A

Fill with water at least

2" (51 mm) above

the highest jet.

Position the jet

nozzles to direct

the water flow as

desired.

Press the air switch to turn the

whirlpool on or off.

Kohler Co.