Kohler Archer K-1124-RA-0 Handleiding voor huiseigenaren - Pagina 4
Blader online of download pdf Handleiding voor huiseigenaren voor {categorie_naam} Kohler Archer K-1124-RA-0. Kohler Archer K-1124-RA-0 24 pagina's. Bath whirlpools
Pagina afdrukken
Turn the jet trim ring
clockwise to
decrease the flow.
Turn the jet trim ring counterclockwise
to increase the flow.
Operating Your Whirlpool
Operation
Position the jet nozzles to face down toward the basin. Turn the jet trim rings fully
counterclockwise.
NOTE: The water temperature in the whirlpool should never exceed 104°F (40°C).
Close the drain, then fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.
Use your hand to test the water temperature for comfort and safety, then carefully enter the
whirlpool.
Press the air switch to turn on the pump to the whirlpool.
NOTE: If equipped, the heater will also turn on.
Adjust the jets for optimum air/water mixture. Turn the jet trim rings clockwise to reduce the flow
or counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired
to maximize your hydro-massage experience.
Press the air switch a second time to turn off the pump the whirlpool.
Carefully exit the whirlpool, then open the drain to empty the water from whirlpool.
NOTE: If the whirlpool does not function properly, please refer to the "Troubleshooting" section.
Cleaning Your Whirlpool
For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
Cleaning information, call 1-800-456-4537.
1421656-5-A
Fill with water at least
2" (51 mm) above
the highest jet.
Position the jet
nozzles to direct
the water flow as
desired.
Press the air switch to turn the
whirlpool on or off.
4
Kohler Co.