Aqua Creek Products F-004XRDD-NA Manual - Page 9

Browse online or download pdf Manual for Lifting Systems Aqua Creek Products F-004XRDD-NA. Aqua Creek Products F-004XRDD-NA 18 pages. Pool lift without anchor

Print Page

Pro Pool-XR Deep Draft Assembly Instructions

Attach seat belt to the seat as shown in the figure to the right.

Install the Pro Pool-XR Deep Draft pool lift onto the three

(3) anchors using the supplied 1/2 x 1-1/2" stainless steel hex

bolts and 1/2" stainless steel flat washers. Apply anti-seize to all

hardware to prevent lift from seizing in the anchor. Make sure all

bolts are tight before using the lift.

"charge" light illuminates when the battery

is being charged.

Remove the fully-charged battery from

the charger, grease the terminals, and

install it on top of the Control Box. The

battery will line up square with the control

box, and will 'click' when it locks in place

properly. The lift will only operate when

the battery is mounted properly.

WHEN NOT IN USE STORE THE BATTERY

ON THE CHARGER. DO NOT LEAVE THE

BATTERY ON THE LIFT WHEN NOT IN USE!

Apply dielectric grease

to the plug terminals.

Plug the handset cable

into the large handset socket on the bottom of the control

box. Press the cord end firmly into the socket until it is

all the way recessed into the socket. Failure to fully push

the remote cord into the socket may result in faulty or

interrupted operation.

Before installing the battery, place it on the charging

unit and let it charge for 24 hours. Make sure the orange

ATTACH FULLY-

CHARGED BATTERY

CONTROL BOX

1/2" X 1-1/2" BOLT (3)

1/2" FLAT WASHER (3)

ANCHORS (3)

INSTALLED FLUSH

W/DECK SURFACE

LOOP ON TOP

FOR EASY ACCESS

THREAD THROUGH

SLOTS AND PINCH

TOGETHER TO HOLD

Revised 12/3/15