Aqua Creek Products Pro Pool-XR Manual - Page 9

Browse online or download pdf Manual for Lifting Systems Aqua Creek Products Pro Pool-XR. Aqua Creek Products Pro Pool-XR 20 pages.

Print Page

Attach seat belt to the seat as shown.

Install the Pro Pool-XR pool lift onto the three (3) anchors

using the supplied 1/2 x 1-1/2" stainless steel hex bolts and 1/2"

stainless steel at washers. Apply anti-seize to all hardware to

prevent lift from seizing in the anchor. Make sure all bolts are

tight before using the lift.

"charge" light illuminates when the battery

is being charged.

Remove the fully-charged battery from

the charger, grease the terminals, and

install it on top of the Control Box. The

battery will line up square with the control

box, and will 'click' when it locks in place

properly. The lift will only operate when

the battery is mounted properly.

WHEN NOT IN USE STORE THE BATTERY

ON THE CHARGER. DO NOT LEAVE THE

BATTERY ON THE LIFT WHEN NOT IN USE!

Pro Pool-XR Assembly Instructions

to the plug terminals.

Plug the handset cable

into the large handset socket on the bottom of the control

box. Press the cord end rmly into the socket until it is

all the way recessed into the socket. Failure to fully push

the remote cord into the socket may result in faulty or

interrupted operation.

unit and let it charge for 24 hours. Make sure the orange

Apply dielectric grease

Before installing the battery, place it on the charging

Revised 11/20/14

V.1.1