Aqua Creek Products Pro Pool-XR Podręcznik - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik dla Systemy podnoszenia Aqua Creek Products Pro Pool-XR. Aqua Creek Products Pro Pool-XR 20 stron.
1.
Attach seat belt to the seat as shown.
2.
Install the Pro Pool-XR pool lift onto the three (3) anchors
using the supplied 1/2 x 1-1/2" stainless steel hex bolts and 1/2"
stainless steel at washers. Apply anti-seize to all hardware to
prevent lift from seizing in the anchor. Make sure all bolts are
tight before using the lift.
"charge" light illuminates when the battery
is being charged.
5.
Remove the fully-charged battery from
the charger, grease the terminals, and
install it on top of the Control Box. The
battery will line up square with the control
box, and will 'click' when it locks in place
properly. The lift will only operate when
the battery is mounted properly.
WHEN NOT IN USE STORE THE BATTERY
ON THE CHARGER. DO NOT LEAVE THE
BATTERY ON THE LIFT WHEN NOT IN USE!
Copyright © 2014 Aqua Creek Products All Rights Reserved
Pro Pool-XR Assembly Instructions
3.
to the plug terminals.
Plug the handset cable
into the large handset socket on the bottom of the control
box. Press the cord end rmly into the socket until it is
all the way recessed into the socket. Failure to fully push
the remote cord into the socket may result in faulty or
interrupted operation.
4.
unit and let it charge for 24 hours. Make sure the orange
Apply dielectric grease
Before installing the battery, place it on the charging
Revised 11/20/14
9
V.1.1