Aqua Creek Products LIBERTY LIFT Installation, Assembly, And Operating Instructions For The Installer - Page 3

Browse online or download pdf Installation, Assembly, And Operating Instructions For The Installer for Lighting Equipment Aqua Creek Products LIBERTY LIFT. Aqua Creek Products LIBERTY LIFT 15 pages.

ASSEMBLY INSTRUCTIONS
LIBERTY Lift
-
TM
1. MOST IMPORTANT:
Carefully inspect the lift upon arrival, noting any damage or
missing parts on the delivery receipt before the delivery truck driver leaves.
If there is damage or missing parts, get a contact name and phone number from the truck driver
and inform him that you will need to file a claim. Contact the trucking company immediately.
Then contact Aqua Creek Products at 888-687-3552. We will assist you in filing a claim and
replacing missing or damaged parts.
If you discover concealed damage after the delivery driver has left, call the trucking company
immediately. You have only three days to report concealed damage to the trucking company.
2. Your Liberty Lift will arrive mostly pre-assembled in a crate. Remove the lift from the crate
and place the lift on the pool deck near where you want to install it.
3. S T O P ! C a r e f u l l y r e a d t h e O w n e r ' s Ma n u a l t h o r o u g h l y b e f o r e p r o c e e d i n g w i t h t h e i n s t a l l a t i o n .
4. Remove the charger and the battery from the equipment box, and place the charger where it can
be conveniently plugged into a 115v outlet.
5. Place the battery on the charger and charge it fully before attempting to operate the lift.
Note the charging time will vary considerably depending upon temperate, age of the battery,
and the residual charge in the battery.
NOTE: For maximum battery life and charge capacity it is recommended that you charge the
24v battery pack as often as is reasonably possible. For example, when the facility is closed for
the night, we recommend that you remove the battery from the lift and place it on the charger.
The wall mountable charger will automatically shut off when the battery is fully charged.
6. Plug the remote control handset into the
jack socket located on the bottom left of the
control box. It is very important to make
sure that the cord is fully recessed into the
control box socket (See Trouble Shooting
Guide).
7. Make sure the two power cords from the
two actuators are plugged into the two
connector jacks marked 1 and 2 located on
the bottom of the control box, just to the
right of the larger remote control plug-in.
Again, take extra care to make sure that the
cords are plugged in all the way and fully
seated (See Trouble Shooting Guide).
3