AVM EVOLUTION CD2 Operating Instructions Manual - Page 13

Browse online or download pdf Operating Instructions Manual for CD Player AVM EVOLUTION CD2. AVM EVOLUTION CD2 19 pages. Cd-player evolution

Print Page

TIP:While in stand by mode the unit cannot be operated via the remote control (or directly on the unit)

until the remote control button ON (22) is reactivated.

IMPORTANT:The CD2 is not disconnected from the mains power supply in stand by mode.We recomm-

mend that you disconnect the mains plug from the power supply. This will prevent damage to the unit during

thunderstorms or prolonged absence (holiday etc).

BASIC FUNCTIONS

The functions of the buttons REPEAT (28), TIME (29), PAUSE (30), STOP (31) and PLAY (32) are the

same as the functions activated by the buttons on the front of the CD2 unit (see above).

Press the button SEARCH'" (25) or SEARCHT (24) to activate the functions "fast forward" or "fast

reverse". Desired parts of a musical title can be sought in this way. Musical play continues during fast forward

and reverse.

Pressing the button SKIP... (27) or SKIPT (26) activates the skip-title function. If a title has been selected

by using the SKIP buttons (26,27), replay will commence at the selected title by pressing the button PLAY

(10 or 32). Previous or following titles can be selected during play by short pressure on the SKIP buttons

(26,27).

TIP: If a title is already being played on your CD2 unit a short pressure on the button SKIPT (26) will start

replay of the music from the beginning of the piece. If you wish to select the previous title immediately press

the button SKIPT (26) again.

DIRECT TITLE SELECTION

After inserting the CD and closing the tray a title can be directly chosen with the relevant remote control

button. To do this you press the button bearing the selected title number. The CD2 searches for the beginn-

ning of the selected piece and play begins immediately.

If you wish to select titles with a selection number greater than 10, simultaneously press the buttons cd-

select (33) and the button> I0 (44). Then enter the first digit followed by the second digit. For this purpose

the button 10 (43) represents the number zero "0" . (Example: to select the title numbered "23" simultane-

ously press buttons cd-select and>

0 (44) followed by the buttons cd-select

(33)

with 2 (35) and cd-select

(33)

with 3 (36).

TIP:To economize on space the remote control has only one numeric block.To operate your CD player you

must always press the buttons cd-select AND the required numeric button simultaneously.