A.J.Antunes 9210822 Manual - Page 7

Browse online or download pdf Manual for Toaster A.J.Antunes 9210822. A.J.Antunes 9210822 20 pages. Club toaster

Print Page

operating Instructions

Follow these steps to start the Club Toaster:

1. Turn the Rocker Switch (power On/Off), located

at the back of the unit, to ON. There will be a 20

second countdown as the unit sets defaults.

2. The unit will start to warm up and will show the

Wait

message in the display (Figure 3).

Note: the Control Panel and display are located

on the back of the unit.

3. When the unit reaches operating temperature, the

display will read Ready (Figure 4).

4. The unit is ready for operation.

PLTN

Wait

PLTN

MOTOR

ADJUST

PRGM

BELTS

STOP/START

figure 3. Club toaster Wait display

PLTN

Ready

PLTN

MOTOR

ADJUST

PRGM

BELTS

STOP/START

figure 4. Club toaster ready display

Note: If the toasting quality needs to be adjusted,

refer to the section titled "adjusting toasting

Quality" in the operation section of this manual.

P/N 1010905 Rev. B 03/12

McDonald's

oPeratIoN

SELECT

Club ToasTer CTX-200

toasting Clubs

Follow these steps to toast Clubs with the Club Toaster:

1. Make sure the unit is turned on and that the dis-

Ready

play reads

2. Insert the club into Bun Feeder as shown in

Figure 5.

3. The club will emerge from the toaster into the Bun

Buffer.

figure 5. CtX-200 toasting route

adjusting toasting Quality

The toasting quality of the CTX-200 can be adjusted

to provide a lighter or more darker toasted product.

Follow these steps to adjust toasting quality.

1. At the back Control Panel, press and release the

adj button (Figure 6).

2. Use the PreV and NeXt buttons to adjust the

toasting quality to lighter or darker respectively

(Figure 6).

Note: Pressing the PreV button decreases toast-

ing darkness. Pressing the NeXt button increases

toasting darkness.

3. Test several clubs to verify that the product is

toasting at the desired quality.

4. If the toasting quality needs further adjustment,

repeat Steps 1 through 3 as necessary.

Note: this setting is maintained when the unit is

powered off.

Note: the adjustment range is +/- 10% of cycle

time. therefore, each adjustment represents a 1%

change toward the desired result.

Note: two bars on the display indicate the adjust-

ment is in the center position.

Club

Large Black Arrows

inside Bun

indicate Club

Feeder

Route through

toaster

Bun Buffer

A.J. Antunes & Co.