A.J.Antunes 9210822 Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Тостер A.J.Antunes 9210822. A.J.Antunes 9210822 20 сторінок. Club toaster
Друкувати сторінкуoperating Instructions
Follow these steps to start the Club Toaster:
1. Turn the Rocker Switch (power On/Off), located
at the back of the unit, to ON. There will be a 20
second countdown as the unit sets defaults.
2. The unit will start to warm up and will show the
Wait
message in the display (Figure 3).
Note: the Control Panel and display are located
on the back of the unit.
3. When the unit reaches operating temperature, the
display will read Ready (Figure 4).
4. The unit is ready for operation.
PLTN
Wait
PLTN
MOTOR
ADJUST
PRGM
CT
BELTS
STOP/START
figure 3. Club toaster Wait display
PLTN
Ready
PLTN
MOTOR
ADJUST
PRGM
CT
BELTS
STOP/START
figure 4. Club toaster ready display
Note: If the toasting quality needs to be adjusted,
refer to the section titled "adjusting toasting
Quality" in the operation section of this manual.
P/N 1010905 Rev. B 03/12
McDonald's
oPeratIoN
PREV
NEXT
SELECT
PREV
NEXT
SELECT
Club ToasTer CTX-200
toasting Clubs
Follow these steps to toast Clubs with the Club Toaster:
1. Make sure the unit is turned on and that the dis-
Ready
play reads
2. Insert the club into Bun Feeder as shown in
Figure 5.
3. The club will emerge from the toaster into the Bun
Buffer.
figure 5. CtX-200 toasting route
adjusting toasting Quality
The toasting quality of the CTX-200 can be adjusted
to provide a lighter or more darker toasted product.
Follow these steps to adjust toasting quality.
1. At the back Control Panel, press and release the
adj button (Figure 6).
2. Use the PreV and NeXt buttons to adjust the
toasting quality to lighter or darker respectively
(Figure 6).
Note: Pressing the PreV button decreases toast-
ing darkness. Pressing the NeXt button increases
toasting darkness.
3. Test several clubs to verify that the product is
toasting at the desired quality.
4. If the toasting quality needs further adjustment,
repeat Steps 1 through 3 as necessary.
Note: this setting is maintained when the unit is
powered off.
Note: the adjustment range is +/- 10% of cycle
time. therefore, each adjustment represents a 1%
change toward the desired result.
Note: two bars on the display indicate the adjust-
ment is in the center position.
7
.
Club
Large Black Arrows
inside Bun
indicate Club
Feeder
Route through
toaster
Bun Buffer
A.J. Antunes & Co.