Aqua Logic DS series Installation & Operating Instructions - Page 2

Browse online or download pdf Installation & Operating Instructions for Chiller Aqua Logic DS series. Aqua Logic DS series 4 pages. Water-cooled

Print Page

WARNING!!!

THIS DEVICE USES HIGH VOLTAGE ELECTRICAL POWER FOR OPERATION.

SAFETY PRECAUTIONS MUST BE OBSERVED.

CAREFULLY READ AND OBSERVE THE FOLLOWING TO AVOID ELECTRICAL SHOCK

OR SEVERE DAMAGE TO THE CONTROLLER.

We recommend, as with all electrical equipment used in or around water, that you connect your electrical

equipment to a ground-fault interrupt (GFI) protection circuit.

ALWAYS turn the power off for the equipment at the source (circuit breaker) if there is any electrical

problem, the electrical equipment or controller has been submerged or sprayed with water.

ALWAYS make sure that the electrical circuit you connect your electrical equipment to is rated at least

20% higher than the maximum current rating on the equipment.

ALWAYS make sure that you operate the equipment and controller at the correct voltage.

Do NOT submerge controller in water.

Do NOT allow water to drip or spray on or into controller.

Do NOT attempt to turn off the power at the chiller or controller if a problem occurs. Disconnect unit at the

main power panel.

Do NOT attempt to repair equipment. Call Aqua Logic for instructions.

NOTICE:

Inspect the chiller for shipping damage. If damaged, contact Aqua Logic.

Aqua Logic®, Inc.

8268 Clairemont Mesa Blvd. Suite 302

San Diego, CA 92111

Tel: (858) 292-4773 Fax: (858) 279- 0537