Aqua Logic DS series Kurulum ve Kullanım Talimatları - Sayfa 2

Soğutucu Aqua Logic DS series için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları indirin. Aqua Logic DS series 4 sayfaları. Water-cooled

Sayfayı Yazdır
WARNING!!!
THIS DEVICE USES HIGH VOLTAGE ELECTRICAL POWER FOR OPERATION.
SAFETY PRECAUTIONS MUST BE OBSERVED.
CAREFULLY READ AND OBSERVE THE FOLLOWING TO AVOID ELECTRICAL SHOCK
OR SEVERE DAMAGE TO THE CONTROLLER.
We recommend, as with all electrical equipment used in or around water, that you connect your electrical
equipment to a ground-fault interrupt (GFI) protection circuit.
ALWAYS turn the power off for the equipment at the source (circuit breaker) if there is any electrical
problem, the electrical equipment or controller has been submerged or sprayed with water.
ALWAYS make sure that the electrical circuit you connect your electrical equipment to is rated at least
20% higher than the maximum current rating on the equipment.
ALWAYS make sure that you operate the equipment and controller at the correct voltage.
Do NOT submerge controller in water.
Do NOT allow water to drip or spray on or into controller.
Do NOT attempt to turn off the power at the chiller or controller if a problem occurs. Disconnect unit at the
main power panel.
Do NOT attempt to repair equipment. Call Aqua Logic for instructions.
NOTICE:
Inspect the chiller for shipping damage. If damaged, contact Aqua Logic.
Aqua Logic®, Inc.
8268 Clairemont Mesa Blvd. Suite 302
San Diego, CA 92111
Tel: (858) 292-4773 Fax: (858) 279- 0537
www.aqualogicinc.com