Aqua One AquaStyle 850 User Manual - Page 8

Browse online or download pdf User Manual for Aquariums Aqua One AquaStyle 850. Aqua One AquaStyle 850 13 pages. Aquarium
Also for Aqua One AquaStyle 850: Instruction Manual (16 pages), Assembly Instructions (4 pages), Quick Start Manual (2 pages)

Print Page

Filter Maintenance

WEEKLY

Turn the Power Head off.

2. Remove the Lids from the Filter Unit.

3. Remove the Elbow and Spray Bar unit from

the top of the Power Head.

4. Remove the Carbon Cartridges and Black

Sponges from the Filter Unit.

5. Empty a small amount of water from the

aquarium into a bucket.

6. Rinse the

Black Sponges

Discard the used water; do not add it back into the

aquarium.

7. Rinse the Carbon Cartridges out under the

tap, rinse thoroughly.

8.Re-insert the Black Sponges

Cartridges.

9. Then connect the Elbow and the Spray Bar

unit back onto the outlet at the top of the Power

Head. Make sure the holes of the Spray Bar has

the cap fitted.

10. Ensure the aquarium is full. Refer to point

number 31 in set up instructions.

11. Turn the Power Head back on and ensure

that water is flowing out of the Spray Bar.

12. Replace the Lids on the Filter Unit.

13. Add a filter supplement.

The Carbon filter cartridges should be replaced

every 6-8 weeks for optimum filter performance.

MONTHLY See diagrams on next page...

1. Turn the power off and unplug both power leads.

2. Remove the Light Unit and place it somewhere

safe away from water and where it will not be

broken/ damaged.

3. Remove Filter Unit from aquarium and take to

sink and remove the Lids.

4. Disconnect Spray Bar and Elbow and clean

with double ended pipe brush.

5. Slide the Power Head off the bottom of the

Filter Unit.

6. You will need a flat head screw driver.

7. Holding the Power Head upside down insert

the screwdriver into the larger slot of the Power

Head.

8. Carefully leaver the screw driver downwards.

9. This will pop one side of the Impeller Cap off.

in the bucket.

10. Turn the Power Head around, repeat steps

7,8&9.

11. Grasp the Impeller Cap and remove it from

the Motor. fig5

12. Remove the Impeller (If it does not come out

and Carbon

when the Impeller Cap is removed)

13. Use a double ended pipe brush to clean

Impeller and inside of Impeller Well.

14. Also run a pipe brush through the Outlet at

the top of the Power Head.

15. Clean the Intake Pipe and Strainer thoroughly.

16. Reconnect all parts and place Filter Unit back

onto the aquarium.

17. Ensure the power lead is not wet and plug it

back in.

18. Turn the power back on and check that water

is flowing through the Spray Bar.

19. Replace the Light Unit and Lids on the filter

unit.

YEARLY

The ceramic noodles are designed to be

maintenance free,

NEVER RINSE THEM IN TAP WATER

See Hints & Tips for Best Results and for more

information.