Aqua One AquaStyle 850 Руководство пользователя - Страница 8

Просмотреть онлайн или скачать pdf Руководство пользователя для Аквариумы Aqua One AquaStyle 850. Aqua One AquaStyle 850 13 страниц. Aquarium
Также для Aqua One AquaStyle 850: Руководство по эксплуатации (16 страниц), Инструкции по сборке (4 страниц), Краткое руководство по эксплуатации (2 страниц)

Печатать страницу
Aqua One AquaStyle 850 Руководство пользователя

Filter Maintenance

WEEKLY
Turn the Power Head off.
1.
2. Remove the Lids from the Filter Unit.
3. Remove the Elbow and Spray Bar unit from
the top of the Power Head.
4. Remove the Carbon Cartridges and Black
Sponges from the Filter Unit.
5. Empty a small amount of water from the
aquarium into a bucket.
6. Rinse the
Black Sponges
Discard the used water; do not add it back into the
aquarium.
7. Rinse the Carbon Cartridges out under the
tap, rinse thoroughly.
8.Re-insert the Black Sponges
Cartridges.
9. Then connect the Elbow and the Spray Bar
unit back onto the outlet at the top of the Power
Head. Make sure the holes of the Spray Bar has
the cap fitted.
10. Ensure the aquarium is full. Refer to point
number 31 in set up instructions.
11. Turn the Power Head back on and ensure
that water is flowing out of the Spray Bar.
12. Replace the Lids on the Filter Unit.
13. Add a filter supplement.
The Carbon filter cartridges should be replaced
every 6-8 weeks for optimum filter performance.
MONTHLY See diagrams on next page...
1. Turn the power off and unplug both power leads.
2. Remove the Light Unit and place it somewhere
safe away from water and where it will not be
broken/ damaged.
3. Remove Filter Unit from aquarium and take to
sink and remove the Lids.
4. Disconnect Spray Bar and Elbow and clean
with double ended pipe brush.
5. Slide the Power Head off the bottom of the
Filter Unit.
6. You will need a flat head screw driver.
7. Holding the Power Head upside down insert
the screwdriver into the larger slot of the Power
Head.
8. Carefully leaver the screw driver downwards.
9. This will pop one side of the Impeller Cap off.
in the bucket.
10. Turn the Power Head around, repeat steps
7,8&9.
11. Grasp the Impeller Cap and remove it from
the Motor. fig5
12. Remove the Impeller (If it does not come out
and Carbon
when the Impeller Cap is removed)
13. Use a double ended pipe brush to clean
Impeller and inside of Impeller Well.
14. Also run a pipe brush through the Outlet at
the top of the Power Head.
15. Clean the Intake Pipe and Strainer thoroughly.
16. Reconnect all parts and place Filter Unit back
onto the aquarium.
17. Ensure the power lead is not wet and plug it
back in.
18. Turn the power back on and check that water
is flowing through the Spray Bar.
19. Replace the Light Unit and Lids on the filter
unit.
YEARLY
The ceramic noodles are designed to be
maintenance free,
NEVER RINSE THEM IN TAP WATER
See Hints & Tips for Best Results and for more
information.
8