AVPro Edge ConferX AC-CXMF62-AUHD Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Matrix Switcher AVPro Edge ConferX AC-CXMF62-AUHD. AVPro Edge ConferX AC-CXMF62-AUHD 6 pages. 6 input, 2 output multi-format classroom/conference room matrix switcher

buttons
• HDBT Output Select button - Toggles the active source for HDBT OUTPUT
• HDMI Output Select button - Toggles the active source for HDMI Output
buttoN Commands
• Enable/Disable "Auto-Switching" - Simply PRESS & HOLD the OUTPUT SELECT button for 4 seconds to toggle
"Auto-Switching"
• When the LED is flashing "Auto-Switching" is enabled.
• You can enable only one output to auto switch, or both - when both are enabled, they will be mirrored.
• EDID is ideally set from the Web Interface, but can be set from the front panel (will be walked through later in
the guide)

Controlling the Matrix:

Web Interface

• To connect to the Matrix Switch and access the Web interface:
• Connect the LAN port on the rear of the Matrix Switch into an active access point or router
• Make sure your computer is on the same network
• Open any web browser and type in the IP address of the Matrix Switch. *NOTE - The default IP address is:
192.168.001.239
NOTE: Use this area to route inputs to outputs