AVPro Edge AC-CXWP-KVM-KIT Quick Start Manual

Browse online or download pdf Quick Start Manual for Extender AVPro Edge AC-CXWP-KVM-KIT. AVPro Edge AC-CXWP-KVM-KIT 4 pages. Hdmi & bi-directional usb extension kit with hdbaset technology

AVPro Edge AC-CXWP-KVM-KIT Quick Start Manual
ac-CXWP-KVM-kit
HDMI & Bi-Directional USB Extension Kit
Quick Start Guide
AVPro Edge's ConferX Dual Gang Wall Plate presents a Full 4k60 444 KVM solution
for anything from the home office to the classroom. Fully integrate with today's
interactive displays using bidirectional USB and ARC up to 40 meters over a single
category cable.
This guide will walk you through the following topics:
• Installation
• EDID Management
• Scaling
• Test Pattern Generator
• IR Control Signals
• RS232 Control Signals
• Audio Extraction
• ARC
• USB Extension
• Troubleshooting
installation
1. Install a CAT5e (or better) cable between the display and the source (be sure
to follow local low voltage code. This varies state to state).
2. The Tx has an HDMI input. Connect this to the output of the source with an
18Gbps HDMI cable
3. The Rx has an HDMI output. Connect this to the input of the display with an
18Gbps HDMI cable.
4. Both the Tx and Rx have an RJ45 HDBT connector. Connect each end of the
installed Category cable to these ports.
5. Install the TX Wall Plate into the dual gang box
6. Connect the orange 2 Pin Phoenix power supply to the RX, setting the RX POE
Switch to the "RX" Position
*NOTE - Only use the included power supply
EDID management/Scaling
The EDID Management Pin Wheel allows
you to manage the input device (typically the
display) to request specific video resolutions
and/or audio codecs from a source. EDID Pin
Wheel also allows for downscaling for use with newer sources and legacy displays.
HDB
T technology
with
ase