AVProConnect AC-EX70-UHD User Manual - Page 8

Browse online or download pdf User Manual for Extender AVProConnect AC-EX70-UHD. AVProConnect AC-EX70-UHD 16 pages. 4k hdmi 2.0 extender with hdcp 2.2
Also for AVProConnect AC-EX70-UHD: User Manual (12 pages), User Manual (12 pages)

Print Page

AC-EX70-UHD-KIT

Indicator Troubleshooting Lights on the Transmitter (cont.)

LINK - Above RJ45 (HDBT) Port:

between the Tx and Rx is intact. This light should ALWAYS be solid. If this light is

flashing or not present attempt following:

1. Check the length. The maximum distances are 40m (131ft) on 4K and 70m (230ft)

on 1080P.

2. Remove any coils of cable and make sure that there is not excess cabling.

3. Bypass all patch panels and punch-down blocks.

4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is

valid, something may be slightly off.

5. Contact AVProConnect if these suggestions do not work.

STATUS- Above RJ45 (HDBT) Port:

power is present between the Transmitter and Receiver. This light ALWAYS BLINKS

steadily indicating everything is OK. If you do not see this light, attempt the following:

1. Check the length. The maximum distances are 40m (131ft) on 4K and 70m (230ft)

on 1080P.

2. Remove any coils of cable and make sure that there is not excess cabling.

3. Bypass all patch panels and punch-down blocks.

4. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is

valid, something may be just slightly off.

5. Try powering from the Receiver instead of the Transmitter (See Receiver page for

more about PoE direction).

6. Contact AVProConnect if these steps do not work.

Powering the System

Bi-Directional Power - The AC-EX70-UHD-KIT allows you to choose where you power

the system. You have to power options:

1. From the HDBaseT Tx - In this mode power will be supplied to the Rx through the

CAT cable.

2. From the HDBaseT Rx - In this mode power will be supplied to the Tx through the

CAT Cable (This is known as "Reverse Power)

NOTE: There is no button or switch to set the mode - Simply plug the power supply into

the Tx or Rx and the system will electronically know what to do.

(Green)

This indicator shows that the AV HDBT link

(Amber)

This is an indicator showing that the