AVS 6000 User Manual - Page 4

Browse online or download pdf User Manual for Car Alarm AVS 6000. AVS 6000 7 pages. Alarm system

Print Page

Learning new remotes:

To add a new remote to the system follow the procedure below:

1. Turn the vehicle's ignition on

2. Immediately press and hold the bottom button on the original remote until the

siren starts to beep (approximately 4 seconds) and then release the button

3. Immediately press and hold the bottom button on the new remote for at least 4

seconds

4. Turn off the ignition

5. The new remote is now programmed into the system.

NOTE: If there are no valid remotes available the module will need to be returned to

the supplier for reprogramming.

Detailed below is a complete list of programmable features that can either be turned

on or off.

We have set at the factory the most common configuration and these settings are

listed in the REGISTER setting below. Once the desired features have been

selected, the selection is permanently retained in the memory even if the power is

removed.

To turn on or turn off any feature use the following procedure: e.g. to enable

passive arming:

1. Find the REGISTER (1, 2 or 3) in which the feature is located. (e.g. passive

arming is located in REGISTER 1)

2. Set the vehicle up as described to access REGISTER 1, (doors closed,

bonnet closed, turn the ignition on last)

3. Press the bottom button on the remote the number of times for the feature's

code (e.g. 5 times for passive arming)

4. Turn the ignition off

5. The siren will then confirm which features are turned on via audible readout. If

a feature is turned on the siren will chirp its code corresponding to the number

shown in the column "Number of pushes". The siren in this example will beep

in order: once, then twice etc up to five times. This shows that all features

except 6 and 7 are now turned on. Please note that that feature 9 is excluded

from the confirmation chirps.

PROGRAMMABLE FEATURES