Allied Telesis Rapier AR 700 Series How To Configure - Page 4
Browse online or download pdf How To Configure for Network Router Allied Telesis Rapier AR 700 Series. Allied Telesis Rapier AR 700 Series 6 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis Rapier AR 700 Series: Troubleshooting Manual (8 pages), Troubleshooting (5 pages), Quick Install Manual (13 pages), How-To (8 pages)
Print Page
An example scenario for RIP over L2TP
Routing Considerations
A routing issue to consider in this set up is the fact that RIP is relatively slow to react to
route changes as it only updates, by default, every 30 seconds.
To improve the responsiveness of RIP you can alter the default timers for updating, flushing
and so on. You do need to keep in mind that if you lose some packets (quite possible across
a lossy Internet connection) some of your routes may flap too much. So the RIP timers need
to be adjusted to provide an optimal compromise between responsiveness and robustness.
In this particular example, the various RIP timers are set at half default value.
set ip riptimer update=15 invalid=90 holddown=60 flush=150
Consideration would need to be given to each specific set up to get an optimal balance when
adjusting these timers.
Page 4 | AlliedWare™ OS How To Note: Dynamic Routing over L2TP