Allied Telesis Rapier AR 700 Series How To Configure
Browse online or download pdf How To Configure for Network Router Allied Telesis Rapier AR 700 Series. Allied Telesis Rapier AR 700 Series 6 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis Rapier AR 700 Series: Troubleshooting Manual (8 pages), Troubleshooting (5 pages), Quick Install Manual (13 pages), How-To (8 pages)
AlliedWare™ OS
Configure Dynamic Routing Over An L2TP Tunnel
How To |
Introduction
This How To Note shows an example of using a dynamic routing protocol over an L2TP
tunnel.
Running dynamic routing protocols over a secure Internet connection can be a complex
issue, with the possibility of intermittent connections causing routing problems.
OSPF (or BGP) are more connection-oriented than RIP and therefore are more susceptible
to problems caused by intermittent loss of connection between 'neighbours'. A neighbour
that may bounce up and down can cause havoc to the correct propagation of OSPF routing
information for a network.
The following example scenario is for setting up RIP over an L2TP tunnel. RIP is simpler and
has less overhead and control, so it provides a more robust setup as a dynamic routing
protocol over an L2TP tunnel.
Which products does it apply to?
This Note applies to the following Allied Telesis routers, running software version 2.6.1 or
later:
AR400 series
AR700 series
C613-16037-00 REV C
www.alliedtelesis.com