Allied Telesis Rapier AR 700 Series Как настроить

Просмотреть онлайн или скачать pdf Как настроить для Сетевой маршрутизатор Allied Telesis Rapier AR 700 Series. Allied Telesis Rapier AR 700 Series 6 страниц. How to set up pppoe between a linux client and access concentrator
Также для Allied Telesis Rapier AR 700 Series: Руководство по устранению неполадок (8 страниц), Устранение неполадок (5 страниц), Руководство по быстрой установке (13 страниц), Как сделать (8 страниц)

AlliedWare™ OS

Configure Dynamic Routing Over An L2TP Tunnel

How To |

Introduction

This How To Note shows an example of using a dynamic routing protocol over an L2TP

tunnel.

Running dynamic routing protocols over a secure Internet connection can be a complex

issue, with the possibility of intermittent connections causing routing problems.

OSPF (or BGP) are more connection-oriented than RIP and therefore are more susceptible

to problems caused by intermittent loss of connection between 'neighbours'. A neighbour

that may bounce up and down can cause havoc to the correct propagation of OSPF routing

information for a network.

The following example scenario is for setting up RIP over an L2TP tunnel. RIP is simpler and

has less overhead and control, so it provides a more robust setup as a dynamic routing

protocol over an L2TP tunnel.

Which products does it apply to?

This Note applies to the following Allied Telesis routers, running software version 2.6.1 or

later:

AR400 series

AR700 series

C613-16037-00 REV C