Allied Telesis Rapier AR 700 Series How-To - Page 3

Browse online or download pdf How-To for Network Router Allied Telesis Rapier AR 700 Series. Allied Telesis Rapier AR 700 Series 8 pages. How to set up pppoe between a linux client and access concentrator
Also for Allied Telesis Rapier AR 700 Series: How To Configure (6 pages), Troubleshooting Manual (8 pages), Troubleshooting (5 pages), Quick Install Manual (13 pages)

Allied Telesis Rapier AR 700 Series How-To
Configuring Your Linux Device
!
1. Set a host name. The host name must be a user on the Allied Telesis device. To set a default
hostname on your linux device, use "hostname <newname>":
[root@linux_client michael]# hostname
linux_client
2. Check the ppp options file. The options file is not used when this particular pppd link is started.
However, if it is used, it should look like this:
[root@linux_client michael]# cat /etc/ppp/options
lock
#debug
#novj
#require-pap
3. Check the CHAP secrets file. In this configuration there are a number of lines that are
commented out but only the last line is used. The last line of your CHAP secrets file should look
like this (as underlined in output below):
[root@linux_client michael]# cat /etc/ppp/chap-secrets
# Secrets for authentication using CHAP
# client
#
#*
#tester
#*
#eightbit
#manager
linux_client
Set Up PPPoE Between a Linux Client and an Allied Telesis Access Concentrator
Configure your Linux device as follows:
server
test
*
*
*
pptpd
*
secret
IP addresses
password
*
12345678
1.1.1.1
eightbit
*
eightbit
1.1.1.2
friend
*
password
*
3