Dell EMC PowerStore Quick Start Manual - Page 7
Browse online or download pdf Quick Start Manual for Storage Dell EMC PowerStore. Dell EMC PowerStore 8 pages.
Also for Dell EMC PowerStore: Quick Start Manual (8 pages)
Print Page
10. Discover your system
Next, discover your newly installed base enclosure, and then create a cluster.
Note: The procedure in this section only applies if you are physically present within the datacenter. If you do not have access
to the base enclosure, download and run the PowerStore Discovery Utility on a remote system or virtual machine to discover
your system. Refer to the networking guide for your model for more information on setting up your workstation and using the
PowerStore Discovery Utility.
Before you begin:
•
(Optional) Download and run the PowerStore Network Validation Tool (NVT) to validate that your networks are
correctly configured. The NVT can be downloaded from Dell EMC Central Solutions at
https://central.dell.com/central/home.
•
Ensure that your workstation's network adapter is configured as follows:
o
Connected directly to the PowerStore service port on Node B
o
Configured with a static IP address on the service LAN network (128.221.1.0/24) with no gateway address
defined (128.221.1.249; 255.255.255.0; no gateway)
o
Able to ping the IP address of Node B's service LAN port (128.221.1.251)
1.
Connect your workstation or laptop to the service port on Node B of the base enclosure.
2.
In a web browser, go to https://128.221.1.251.
Log on to PowerStore Manager and begin the initial configuration process using the following default credentials:
Username: admin
Default password: Password123#
Note: You must change this default password during initial configuration.
You can disconnect the workstation or laptop from the service port after the initial configuration process is complete.
What's next?
Use the information from the Initial Configuration Worksheet in the networking guide to configure your cluster for use.
Dell EMC PowerStore Quick Start Guide
B
A
Page 7 of 8