Dell EqualLogic PS Series Hardware Owner's Manual - Page 18
Browse online or download pdf Hardware Owner's Manual for Storage Dell EqualLogic PS Series. Dell EqualLogic PS Series 50 pages. Storage arrays
Also for Dell EqualLogic PS Series: Setting Up (2 pages), Hardware Owner's Manual (48 pages), Hardware Maintenance (46 pages)
Print Page
PS6610 Hardware Owner's Manual
Item
Description
1
Drive status indicator (LED)
Installing and Removing Disk Drives
The proper insertion and seating of hard drives in the chassis drawers is critical to the operation of the
array. For proper cooling, do not remove a failed drive until it can be replaced with another.
You should always wear electrostatic protection when handling a drive. See
Note:
Protection on page
6.
Install Disk Drives
The 3.5-inch drives and 2.5-inch drives come preconfigured in their carriers (DDICs) and are installed
vertically into the top of the open drawer with the large arrow pointing toward the rear of the chassis.
Note:
Installing a drive is easier if you work from the side of the open drawer.
1. Hold the drive by the carrier and slide the drive most of the way into a slot.
2. Using both hands (thumbs and forefingers), apply downward pressure firmly and equally across
the carrier (see
Figure
3. While maintaining downward pressure, slide the drive carrier's top plate toward the back of the
drawer until the release button in the center clicks into place (see
It is possible for a drive to appear seated but not be fully locked into position, eventually
Note:
causing it to dislodge itself. After installing a drive, check the release button in the center of the
carrier. If the drive is not fully locked into position, a yellow line will be visible underneath the arrow
button. If the yellow line is visible, remove the drive and reinstall it.
12
Table 7: Drive LED States
Indicator States
•
Off — Drive OK
•
Amber — Drive failed
•
Blinking — Drive identification
8).
2 Drive Maintenance
Hardware
Figure
9).