Dell Force10 S4810 Configuration Manual - Page 8

Browse online or download pdf Configuration Manual for Switch Dell Force10 S4810. Dell Force10 S4810 17 pages. Dell force10 s4810 switch
Also for Dell Force10 S4810: Quick Start Manual (27 pages), Deployment Manual (36 pages), Configuration Manual (17 pages)

Print Page

2.4

Configure route for OOB management port (optional)

Force10(conf)#management route X.Y.Z.0 /24 A.B.C.1

Note: X.Y.Z.0 is the network your management system is connecting from and A.B.C.1 is the gateway for

the switch. If your management system is on the same subnet as the switch, the previous step may be

omitted. The example above assumes a class C subnet mask.

2.5

Configure login credentials

FTOS(conf)#username admin privilege 15 password 0 yourpassword

FTOS(conf)#enable password level 15 0 yourpassword

2.6

Enable iSCSI optimization feature

This feature is enabled when EqualLogic arrays are connected. It automatically performs the following:

• Configures jumbo frames to 12k on all ports.

• Disables unicast storm.

• Enables spanning tree portfast on ports connected to EqualLogic arrays.

• Configures flowcontrol on all ports (rx on tx off).

Note: Spanning tree portfast must be manually configured for host facing ports. Refer to section 2.8.

FTOS#configure

FTOS(conf)#iscsi enable

FTOS(conf)#exit

2.7

Enable switch ports

Option 1: You can enable the array or host facing ports individually.

Note: This method is more secure than Option 2.

FTOS#configure

FTOS(conf)#interface tengigabitethernet 0/0

FTOS(conf-if-te-0/0)#switchport

FTOS(conf-if-te-0/0)#no shutdown

FTOS(conf-if-te-0/0)#exit

FTOS(conf)#exit

SCG1000

Force10 S4810 Configuration Guide