3 Day Blinds VERTICAL BLINDS Getting Started - Page 4

Browse online or download pdf Getting Started for Window Blinds 3 Day Blinds VERTICAL BLINDS. 3 Day Blinds VERTICAL BLINDS 10 pages.

Print Page
INSIDE MOUNT
INSIDE MOUNT WITHOUT A VALANCE BRACKET

INSTALLATION

BEFORE YOU START: A minimum window depth of 2
for 3
/
" vanes, 3
/
" for 5" vanes and 6
1
3
2
4
required in order for the blind to operate properly. Be sure to
check for any obstructions, such as window cranks or door
handles that may add to this minimum depth.
4
| Vertical Blinds
/
7
8
/
" for 10" vanes is
1
4
To install the Mounting Clips:
• Mounting clips must be
positioned flat against
the top of the window
casing with the "tail" of the
mounting clip positioned
closest to the window.
• Mark the casing with a pencil.
• Using a drill and a
/
" drill
1
16
bit or an awl, make a small
pilot hole at each pencil
mark.
• Install the mounting clip
using the screw provided.
• Repeat this procedure for the
opposite end of the window.
• Install any additional
mounting clips provided,
making sure that all screw
holes are marked 1" from the
front edge of the window
casing.
INSIDE MOUNT WITH A VALANCE BRACKET
INSTALLATION
BEFORE YOU START: A minimum depth of 2
in order for the blind to operate properly. Be sure to check
for any obstructions such as window cranks or locks that may
add to the minimum depth.
"
NOTE: Before installing the blind, the valance must be
pre-assembled.
7
/
" is required
8
To Install the Mounting Clip
and Valance:
• For proper installation, the
valance must be positioned
BETWEEN the mounting
clips and the window casing.
• Using a pencil, mark the top
of the valance.
• Repeat this process for the
opposite end of the valance.
• Mark the remaining screw
holes on the valance.
• Using a drill and a
/
" drill
1
8
bit, drill holes through the
valance at the pencil marks.
• Hold the valance up inside of
the window casing making
sure that the valance returns
butt up against the wall on
either side of the window
opening and that the dust
cover is flat against the top
of the window casing.
• Using a pencil, mark the
window casing through
the holes in the top of the
valance.
• Set the valance aside.
• Using a drill with a
/
" drill
1
16
bit or an awl, make a small
pilot hole at each pencil
mark.
• Position the valance over the
screw holes in the window
casing and mount the left
mounting clip using the
screw provided. Make sure
that the mounting clip is
positioned straight and in
line with the "tail" closest to
the window.
• Repeat this procedure for
any additional mounting
clips.