3 Day Blinds VERTICAL BLINDS Getting Started - Page 6

Browse online or download pdf Getting Started for Window Blinds 3 Day Blinds VERTICAL BLINDS. 3 Day Blinds VERTICAL BLINDS 10 pages.

Print Page

CEILING MOUNT

BEFORE YOU START: If you ordered a valance, follow the

instructions for an "Inside Mount with a Valance" Make sure

that all holes drilled in the valance and ceiling are done so

with a drill bit sized to the fasteners purchased.

NOTE: Most ceiling mounts require special fasteners,

available at your local hardware store.

| Vertical Blinds

• Snap the mounting clips onto

the headrail.

• Additional mounting

clips should be spaced

accordingly.

• Using the draw cord, traverse

the carrier clips across the

headrail.

• Hold the vertical headrail up

to the ceiling at the desired

mounting position, making

sure that the back edge of

the headrail is positioned at

the following minimum from

the wall or any obstruction:

• 1

" For 3

" Vanes

• 2

" For 5" Vanes

• 5" For 10" Vanes

• Using a pencil, mark the front

of the mounting clips on the

ceiling surface.

• Remove the mounting clips

from the headrail by pushing

up on the tail of each

mounting clip. Set the blind

aside.

• Facing the window, align

the front of one mounting

clip with the left pencil mark

on the ceiling and mark the

screw hole.

• Using a drill with a drill

bit sized to the fasteners

purchased, drill a hole at

each pencil mark.

• Mount the bracket using the

fasteners purchased.

• Repeat this procedure for

any remaining brackets

making sure that all brackets

are installed straight and in

line.

HEADRAIL INSTALLATION

NOTE: If you purchased a valance for an outside mount blind,

attach the valance clips to the headrail prior to installing the

headrail. Valance clips must be spaced evenly across the

width of the headrail to support the weight of the valance.

Make sure that the valance clips do not interfere with the

mounting brackets.

To Install the Headrail:

• Position the headrail so the blind controls are on the desired

side of the window.

• Hook the front edge of the headrail into the front of the

mounting clips (closest to you).

• Using a firm rolling motion while pressing up slightly on the

tail of the mounting clips, rotate the headrail up and back

until it snaps into the mounting clips.

To Remove the Headrail:

• Push up on the tail of each mounting clip to release the

headrail from the brackets.