Earthlite UV Hot Towel Cabinet Large User Manual - Page 8

Browse online or download pdf User Manual for Food Warmer Earthlite UV Hot Towel Cabinet Large. Earthlite UV Hot Towel Cabinet Large 12 pages. Uv hot towel cabinet

Print Page

SECTION 5: CARE & MAINTENANCE

Cleaning & Ongoing Maintenance

DANGER: RISK OF ELECTRIC SHOCK

Always unplug this furnishing from the electrical outlet before cleaning.

CAUTION

- To prevent permanent damage to the hot towel cabinet surfaces, do not use

abrasive cleaners or scrubbers.

- Do not allow acids or acidic products to remain on the warming drawer's surfaces.

The finish may stain.

Category

Electronics/

Control Panel

Cabinet

Exterior

Cabinet Interior

Gasket

When heating moist towels, condensation can build up inside the cabinet. If not regularly wiped

down, this can lead to small amounts of water dripping from the cabinet when opened.

To minimize any water dripping, ensure you perform the following maintenance tasks as needed

throughout the day:

1) Ensure any condensation and/or moisture (inside and outside the cabinet) is wiped dry with a

soft cloth as needed.

2) Regularly check and wipe down the drip tray.

Cleaning Recommendation

Anti-static electronic aerosol dusters can be used to keep the surfaces of elec-

tronic components, power cables, and plugs free of dust. Exercise caution to

avoid introduction of liquids onto any buttons. Do not use abrasive cleaners

or scrubbers. They may permanently damage the finish or damage the letters

and/or graphics.

Clean the drawer face/handle with a solution of mild detergent and hot

water. Rinse and dry with a soft cloth.

Clean the cabinet interior with a solution of mild detergent and hot water.

Rinse and dry with a soft cloth. Do not use any flammable cleaners inside the

cabinet.

The gasket is located around the edge of the door. Gently clean the gasket

with a solution of mild detergent and hot water. Rinse and dry with a soft

cloth. The gasket material is soft, so be careful not to crush or damage it.

Damaging the gasket will cause a poor heat seal and result in poor warming

drawer performance.