Dell S4100-ON Series Setup Manual - Page 17
Browse online or download pdf Setup Manual for Switch Dell S4100-ON Series. Dell S4100-ON Series 21 pages.
Also for Dell S4100-ON Series: Installation Manual (47 pages), Installation Manual (48 pages), Installation Manual (49 pages)
Print Page
Figure 8. Front rack installation
NOTE:
Do not the use the mounted Ready-Rails as a shelf or a workplace.
3
Tighten the two thumb screws and rack screws.
To remove the chassis from the rack or cabinet, press in the two side-release bars on the chassis at the same time and slide the chassis
forward.
Optics installation
For a list of supported optics, see the S4100–ON Series data sheet at
CAUTION:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the S4100–ON Series and its components.
WARNING:
When working with optical fibers, follow all warning labels and always wear eye protection. Never look directly into
the end of a terminated or unterminated fiber or connector as it may cause eye damage.
1
Position the optic so it is in the correct position.
The optic has a key that prevents it from being inserted incorrectly.
2
Insert the optic into the port until it gently snaps into place.
NOTE:
When you cable the ports, be sure not to interfere with the airflow from the small vent holes above and below
the ports.
www.dell.com/support
or contact your Dell representative.
S4100–ON Series installation
17