HP 226824-001 - ProLiant - ML750 Introduction Manual - Page 6

Browse online or download pdf Introduction Manual for Desktop HP 226824-001 - ProLiant - ML750. HP 226824-001 - ProLiant - ML750 10 pages. Visualization and acceleration in hp proliant servers
Also for HP 226824-001 - ProLiant - ML750: Frequently Asked Questions (4 pages), Implementation Manual (35 pages), Technical White Paper (12 pages), Firmware Update (9 pages), Overview (20 pages), Implementation Manual (26 pages), Introduction Manual (22 pages), Troubleshooting Manual (18 pages), Implementation Manual (11 pages), Installation Manual (2 pages), Configuration Manual (2 pages), Introduction Manual (19 pages), Update Manual (9 pages), Update Manual (16 pages), Introduction Manual (12 pages), Technology Brief (9 pages)

HP 226824-001 - ProLiant - ML750 Introduction Manual

Benefits

The benefits of FB-DIMM architecture include

• Simplified board design

• Higher memory capacity

• Higher performance
• Improved reliability
Simplified board design
FB-DIMMs use a 240-pin socket similar to that used for traditional DDR2 registered DIMMs; however,
FB-DIMMs require significantly fewer signal traces. FB-DIMMs have 69 signal traces compared to 138
traces for DDR2 registered DIMMs. These traces have to be routed to every DDR2 DIMM on the
channel, which complicates board design. FB-DIMMs have additional traces for the secondary links
between sockets, but these traces do not add to overall routing complexity.
In addition, the memory controller and AMB can compensate for signal traces of unequal length, thus
eliminating the need for odd routing paths to make sure the timing is correct. The lower number of
signal traces and the ability to use traces of unequal length greatly simplify board design for FB-
DIMMs.
Higher memory capacity
The point-to-point FB-DIMM architecture enables the electrical load (and signal integrity) for each
channel to remain constant, even as FB-DIMMs are added. This allows system designers to have up to
8 DIMMs per channel (no rank limits) while maintaining a low soft error rate (Figure 5). In
comparison, PC2-3200 SDRAM can have a maximum of 2 dual-rank DIMMs (or 4 single-rank
DIMMs) per channel
.
4
Figure 5. The FB-DIMM architecture allows up to 8 FB-DIMM sockets per channel.
For information about single-rank and dual-rank DIMMs, refer to Memory technology evolution: an overview of
4
system memory technologies technology brief at
http://h18004.www1.hp.com/products/servers/technology/whitepapers/adv-technology.html
.
6