365SMART SM-02-02900 Manual - Page 16

Browse online or download pdf Manual for Sander 365SMART SM-02-02900. 365SMART SM-02-02900 20 pages. Drywall sander

Print Page

• The device creates a vacuum during operation,

which helps to keep the pressure of the sanding

disc against the work surface constant. This force

can be adjusted using the knob on the disc guard

(Fig. 11).

• Thanks to the possibility of dismantling a section of

the disc guard (Fig. 2), the device allows internal

corner grinding. To remove the guard section, press

the lock and slide the piece out of the grinder

guard. This must be done carefully so as not to

break the hooks.

Work:

• Switch on the machine and wait until it is running

at full speed then, holding the sanding pad as

parallel as possible, place it on the work surface.

• Press down lightly on the machine head so that the

sandpaper can contact the work surface.

• Move the grinder slowly at an even speed across

the surface in a smooth motion.

• Apply only as much pressure as necessary to keep

the unit on the work surface. Pressing down too

hard on the device reduces the sanding

performance and may cause unevenness in the

machined surface.

• Keep the product moving at all times, do not stop

in one place to avoid unevenness.

• Remove the product from the work surface before

switching off.

• Always switch off the device first when you have

finished sanding, and only disconnect the bag/

vacuum cleaner with the waste material afterwards.

• The vacuum cleaner/bag with waste should be

emptied regularly.

Replacing the sanding pad

DANGER! Risk of injury from electric shock.

WARNING! Do not connect the tool before

assembly is complete!

1. Insert an Allen spanner (size 5) into the hexagonal

screw on the sanding pad.

2. Hold the sanding pad firmly, then turn the spanner to

remove the pad.

3. Install the new sanding pad by tightening the screw.

CAUTION! Only the recommended sanding pads

should be fitted to the machine.

10. MAINTENANCE

• Keep the product clean. Remove impurities from the

product after each use and before storage.

• Regular and proper cleaning will help ensure safe use

and extend the life of the product.

• Inspect the product for worn and damaged parts

before each use. Do not operate the device if

damaged or worn parts are found.

• Clean the product with a dry cloth. Use a brush for

hard-to-reach places.

• In particular, clean the ventilation openings after

each use with a soft brush.

• Remove persistent dirt with high-pressure air (max 3

bar).

• Check for worn or damaged parts. If necessary,

replace worn parts or contact an authorised service

centre for repair before using the product again.

• This product does not contain any parts that can be

repaired by the consumer. Contact an authorised

service centre to have it checked and repaired.

• If the power cord is damaged, it must be replaced by

an authorised service centre to avoid danger.

• If you need to replace the carbon brushes, have a

qualified repair person do so (always replace two

brushes at the same time).