365SMART SM-02-02900 매뉴얼 - 페이지 16
{카테고리_이름} 365SMART SM-02-02900에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 365SMART SM-02-02900 20 페이지. Drywall sander
페이지 인쇄• The device creates a vacuum during operation,
which helps to keep the pressure of the sanding
disc against the work surface constant. This force
can be adjusted using the knob on the disc guard
(Fig. 11).
• Thanks to the possibility of dismantling a section of
the disc guard (Fig. 2), the device allows internal
corner grinding. To remove the guard section, press
the lock and slide the piece out of the grinder
guard. This must be done carefully so as not to
break the hooks.
Work:
• Switch on the machine and wait until it is running
at full speed then, holding the sanding pad as
parallel as possible, place it on the work surface.
• Press down lightly on the machine head so that the
sandpaper can contact the work surface.
• Move the grinder slowly at an even speed across
the surface in a smooth motion.
• Apply only as much pressure as necessary to keep
the unit on the work surface. Pressing down too
hard on the device reduces the sanding
performance and may cause unevenness in the
machined surface.
• Keep the product moving at all times, do not stop
in one place to avoid unevenness.
• Remove the product from the work surface before
switching off.
• Always switch off the device first when you have
finished sanding, and only disconnect the bag/
vacuum cleaner with the waste material afterwards.
• The vacuum cleaner/bag with waste should be
emptied regularly.
Replacing the sanding pad
DANGER! Risk of injury from electric shock.
WARNING! Do not connect the tool before
assembly is complete!
1. Insert an Allen spanner (size 5) into the hexagonal
screw on the sanding pad.
2. Hold the sanding pad firmly, then turn the spanner to
remove the pad.
3. Install the new sanding pad by tightening the screw.
16
EN
CAUTION! Only the recommended sanding pads
should be fitted to the machine.
10. MAINTENANCE
• Keep the product clean. Remove impurities from the
product after each use and before storage.
• Regular and proper cleaning will help ensure safe use
and extend the life of the product.
• Inspect the product for worn and damaged parts
before each use. Do not operate the device if
damaged or worn parts are found.
• Clean the product with a dry cloth. Use a brush for
hard-to-reach places.
• In particular, clean the ventilation openings after
each use with a soft brush.
• Remove persistent dirt with high-pressure air (max 3
bar).
• Check for worn or damaged parts. If necessary,
replace worn parts or contact an authorised service
centre for repair before using the product again.
• This product does not contain any parts that can be
repaired by the consumer. Contact an authorised
service centre to have it checked and repaired.
• If the power cord is damaged, it must be replaced by
an authorised service centre to avoid danger.
• If you need to replace the carbon brushes, have a
qualified repair person do so (always replace two
brushes at the same time).