ALLNIC AUDIO L-6500 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Amplifier ALLNIC AUDIO L-6500. ALLNIC AUDIO L-6500 14 pages. Line-stage preamplifier

Print Page

You may use balanced (XLR) and single-ended (RCA) outputs at the same time, for example, if

you run one pair to your stereo amplifier and the other(s) to a powered subwoofer. In such a

case, set the output selection switch to unbalanced (RCA OUT – toward rear). This will avoid the

introduction of hum.

REMOTE CONTROL

The remote control provides the ability to remotely:

•

Select the line source input (1 to 5) using either the selector knob or the channel up/down

arrow buttons on the remote control (Please see Figures 4 and 3).

•

Control the volume level using the right (louder) and left (quieter) arrow buttons adjacent

to the channel arrow buttons on the remote control.

•

Mute the volume using the button labeled "MUTE". To raise the volume again after

muting, press the Mute button to take the volume level to where it was prior to muting. In

Mute mode, the "operate" on the front panel of the L-6500 will not be illuminated; it will

illuminate when the L-6500 is unmuted again.

•

Use the red power on/off button in the top left-hand corner of the remote control to

power the L-6500 on and off.

INITIAL POWER-ON

Once you have your L-6500 in place and all connections have been made to your sources and

amplifier(s) and the power cord is installed and plugged into an AC receptacle, you are ready to

turn on the power for your L-6500. Before you power up the L-6500, though, be sure you have:

•

CAREFULLY AND SLOWLY removed ALL the cardboard cushion materials from inside the

tube chimneys

•

ensured the batteries are in the remote control – if not, insert the batteries (by removing

plate on the bottom of the remote control).

•

selected the output connections that you want to use, single-ended (RCA) or balanced (XLR),

using the RCA OUT GROUND switch near the rear of the top plate of the preamplifier.

•

turned the volume down on or muted the L-6500

•

checked that all your connections are snug

Also, be sure you have checked to see that the volume control on the front panel is on the

extreme counter-clockwise position (07 - minimum volume – see Figure 4).

Push the power on-off switch on the left-hand side of the front panel adjacent to the left meter

(See Figure 4) so it is in the "on position", or the red power on/off button in the top left-hand

corner of the remote control (see Figure 3). Once the power has been turned on, the following

will happen on the front panel (Please see Figure 4):

•

the light above the "power" button will illuminate

•

the meters on the front panel will illuminate

•

the light over the line source button that is depressed will illuminate

•

the "operate" light adjacent to the Selector knob will illuminate

The Allnic Audio L-6500 is now ready for operation. At this point, you can power on your sources

and, finally, your stereo power amplifier or mono-blocks.