ALLNIC AUDIO L-6500 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ALLNIC AUDIO L-6500. ALLNIC AUDIO L-6500 14 pagina's. Line-stage preamplifier
Pagina afdrukken
You may use balanced (XLR) and single-ended (RCA) outputs at the same time, for example, if
you run one pair to your stereo amplifier and the other(s) to a powered subwoofer. In such a
case, set the output selection switch to unbalanced (RCA OUT – toward rear). This will avoid the
introduction of hum.
E.
REMOTE CONTROL
The remote control provides the ability to remotely:
•
Select the line source input (1 to 5) using either the selector knob or the channel up/down
arrow buttons on the remote control (Please see Figures 4 and 3).
•
Control the volume level using the right (louder) and left (quieter) arrow buttons adjacent
to the channel arrow buttons on the remote control.
•
Mute the volume using the button labeled "MUTE". To raise the volume again after
muting, press the Mute button to take the volume level to where it was prior to muting. In
Mute mode, the "operate" on the front panel of the L-6500 will not be illuminated; it will
illuminate when the L-6500 is unmuted again.
•
Use the red power on/off button in the top left-hand corner of the remote control to
power the L-6500 on and off.
INITIAL POWER-ON
Once you have your L-6500 in place and all connections have been made to your sources and
amplifier(s) and the power cord is installed and plugged into an AC receptacle, you are ready to
turn on the power for your L-6500. Before you power up the L-6500, though, be sure you have:
•
CAREFULLY AND SLOWLY removed ALL the cardboard cushion materials from inside the
tube chimneys
•
ensured the batteries are in the remote control – if not, insert the batteries (by removing
plate on the bottom of the remote control).
•
selected the output connections that you want to use, single-ended (RCA) or balanced (XLR),
using the RCA OUT GROUND switch near the rear of the top plate of the preamplifier.
•
turned the volume down on or muted the L-6500
•
checked that all your connections are snug
Also, be sure you have checked to see that the volume control on the front panel is on the
extreme counter-clockwise position (07 - minimum volume – see Figure 4).
Push the power on-off switch on the left-hand side of the front panel adjacent to the left meter
(See Figure 4) so it is in the "on position", or the red power on/off button in the top left-hand
corner of the remote control (see Figure 3). Once the power has been turned on, the following
will happen on the front panel (Please see Figure 4):
•
the light above the "power" button will illuminate
•
the meters on the front panel will illuminate
•
the light over the line source button that is depressed will illuminate
•
the "operate" light adjacent to the Selector knob will illuminate
The Allnic Audio L-6500 is now ready for operation. At this point, you can power on your sources
and, finally, your stereo power amplifier or mono-blocks.
8