Miller XMT 304 Owner's Manual - Page 28
Browse online or download pdf Owner's Manual for Welding System Miller XMT 304. Miller XMT 304 40 pages. 4-rack and 6-rack
Also for Miller XMT 304: Owner's Manual (26 pages), Owner's Manual (37 pages)
6-4. Lift-Arc TIG Procedure
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
OM-2208 Page 24
1
1 − 2
"Touch"
Seconds
Do NOT Strike Like A Match!
!
Disconnect power
before maintaining.
Replace
Damaged Or
Unreadable
Labels
2
3 Months
Repair Or
Replace
Cracked
Cables
6 Months
Blow Out Inside
With Process Switch in the Lift-Arc
TIG position, start an arc as follows:
1
TIG Electrode
2
Workpiece
Touch tungsten electrode to work-
piece at weld start point, hold
electrode to workpiece for 1-2
seconds, and slowly lift electrode.
An arc will form when electrode is
lifted.
Normal open-circuit voltage is not
present before tungsten electrode
touches workpiece; only a low
sensing voltage is present between
electrode and workpiece. The
solid-state output contactor does
not energize until after electrode is
touching workpiece. This allows
electrode to touch workpiece with-
out overheating, sticking, or getting
contaminated.
Ref. S-156 279
.
Maintain more often
during severe conditions.
Replace Cracked
Torch Body
Repair Or Replace
Cracked Cables
And Cords
Clean
And
Tighten Weld
Connections