Miller XT30i Owner's Manual - Page 27
Browse online or download pdf Owner's Manual for Welding System Miller XT30i. Miller XT30i 44 pages.
Print Page
6-5. Sequence Of Cutting Operation
Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
!
The pilot arc starts immediately
when trigger is pressed.
Raise trigger lock and press
trigger. Pilot arc starts.
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
.
A complete Parts List is available at www.MillerWelds.com
Pause briefly at end of
cut before releasing trigger.
90
For standard (shielded) cutting, place drag shield on edge
of metal. For extended (non-shielded) cutting, use 3.2 mm
(1/8 in.) standoff distance (dragging tip will reduce tip life).
After cutting arc starts, slowly
start moving torch across metal.
Postflow continues for approx. 20 seconds
after releasing trigger; cutting arc can be
instantly restarted during postflow by raising
trigger lock and pressing trigger.
Ref. 254 087-A
OM-256 118 Page 23