AQUAPHOR OSMO PRO 50 EU Manual - Page 6

Browse online or download pdf Manual for Water Filtration Systems AQUAPHOR OSMO PRO 50 EU. AQUAPHOR OSMO PRO 50 EU 16 pages.

Print Page

Installation Guide

..........................................................................................

ATTENTION! Before installing OSMO Pro, it is

necessary to measure the pressure in the wa-

ter supply system and, if it exceeds 0.63 MPa

(6.5

), use a pressure regulator with the

bar

function of operating in a flow-free mode (the

pressure regulator is not included in the delivery

set, purchase separately).

ATTENTION! To connect OSMO Pro, it is re-

commended to contact the service department

of Aquaphor or regional dealers of Aquaphor.

..........................................................................................

Installing OSMO PRO*

1. For installation you will need: a drill, drill

bits 7 mm and 12 mm, an adjustable wrench,

a screwdriver, a tubular wrench 14 mm.

2. Determine convenient locations for the clean

water tap, operating unit, storage tank, instal-

lation site for the water supply connection

and drain clamp.

Fix the working unit so that the distance be-

tween the bottom point of the cartridges and the

floor is at least 5 cm. This is necessary for the

convenience of replacing the filter cartridges.

Make sure that the connecting pipes are loose

and not bent. Free pipe sections should be se-

cured so that they cannot be damaged or pulled

out of the connections by other objects.

OSMO Pro must be away from or isolated from

heat sources (dishwashers, washing machines,

stoves, boilers, hot water pipes, etc.).

Installation of a tap

for clean water

3. Shut off the cold water line and release the

pressure by opening the mixer.

4. Make sure there is a gasket in the union nut

(15) of the connection unit (23).

5. Drill a 12 mm hole in the sink (countertop).

6. Place the decorative stand (9), a large rubber

gasket (10) on the threaded shank (8) of the

tap and insert the tap into the hole of the sink.

* The manufacturer reserves the right to use components of

a similar design.

Water purifier installation diagr

Housing

2. Water treatment unit

3. Reverse osmosis unit

4. Water conditioning unit

5. Outlet fitting

6. Connecting tube (blue)

with tapered sleeve

Clean water tap

8. Threaded shank

9. Decorative stand

10. Rubber gasket, large

11. Small rubber gasket

12. Plastic lock washer

Position

"valve closed"

Cold water

supply

7. From the bottom of the tabletop, slide a small

rubber gasket (11), plastic (12) and metal (13) lock

washers onto the threaded shank and secure

the valve with a nut (14).

8. Slide the union nut (15) onto the clean water pipe

(6); insert the tube with the end with a metal bush-

ing into the threaded bushing of the valve and

screw the union nut until it stops. Check the tight-

ness of the tube for clean water – with a force of

8–10 kgf, the tube should not be pulled out.

Installing the drain clamp

It is recommended to install the clamp (17) on the

drain of the sink (sink) in front of the siphon (the

13. Me

14. Fix

15. Un

16. Dra

17. Dra

18. Sta

19. Sto

20. Sto

21. Co

22. A t

23. Co

24. Co

con