AquaPRO 02AL017 Instructions - Page 3

Browse online or download pdf Instructions for Water Pump AquaPRO 02AL017. AquaPRO 02AL017 4 pages. Water feature pump

Print Page

MAINTENANCE

DISCONNECT POWER CORD FROM THE POWER SUPPLY BEFORE PERFORMING

MAINTENANCE. NEVER LIFT THE PUMP BY THE POWER CORD.

• Disconnect power cord from the power supply

before performing maintenance. Never lift the

pump by the power cord.

• The only serviceable item is the impellor set. The

motor unit of the pump is encapsulated with epoxy

resin and does not need lubrication.

• All AQUAPRO submersible pumps are water

cooled; if pump becomes restricted it will overheat

and could cause permanent damage. Ensure pump

does not become blocked or restricted.

• The power cord cannot be replaced. If the cord is

damaged, the pump must be discarded.

• The impellor set is a wearing consumable part.

Regular inspections, cleaning and maintenance of

impellor is necessary to ensure longer impellor life. If

the impellor set becomes worn or damaged it should

be replaced (available from your dealer or special

orders). Failure to do so may cause serious damage

to pump.

PART DESCRIPTION

1. FRONT CAGE 2. IMPELLOR COVER 3. IMPELLOR

4. HOSE CONNECTOR 5. MOTOR

AP550 IMAGE SHOWN FOR ILLUSTRATION PURPOSES ONLY

[email protected]

AQUAPRO AP200LV/AP210/AP550/AP750LV Instructions.indd 3

WATER FEATURE PUMP

WWW.AQUAPROONLINE.COM.AU

WEB

I N S T R U C T I O N S

1. Disconnect the power cord from the power supply

before performing maintenance.

2. Remove from water, detach tubing/ fountain kit and

remove front cage from pump.

3. Remove the impellor cover by either turning anti-

clockwise and pulling out or pulling tab to unclip

(depending on model).

4. Gently remove the impellor and shaft, use long nose

pliers if needed. Take care not to break ceramic shaft

(if applicable) because they are brittle.

5. Clean impellor, checking for any signs of wear or

damage.

6. Reinstall the shaft, and then carefully slide the

impellor onto the shaft. The impellor will pull itself in

by magnetic force, this is normal (take care not to

pinch your fingers).

7. Replace the impellor cover making sure the shaft is

located properly on the impellor cover.

8. Replace the front cage.

9. Re-attach tubing/fountain kit, submerse in water,

connect to power supply and turn on.

NOTE:

PLEASE CONSULT YOUR RETAILER

FOR QUALITY ORIGINAL AQUAPRO

REPLACEMENT PARTS FOR YOUR

AQUAPRO PRODUCT.

VISIT WWW.AQUAPROONLINE.COM.AU FOR

NEAREST STOCKISTS.

2/5/2022 11:32 am