AquaPRO 02AL017 Instrukcje - Strona 3

Przeglądaj online lub pobierz pdf Instrukcje dla Pompa wodna AquaPRO 02AL017. AquaPRO 02AL017 4 stron. Water feature pump

AquaPRO 02AL017 Instrukcje
MAINTENANCE
DISCONNECT POWER CORD FROM THE POWER SUPPLY BEFORE PERFORMING
MAINTENANCE. NEVER LIFT THE PUMP BY THE POWER CORD.
• Disconnect power cord from the power supply
before performing maintenance. Never lift the
pump by the power cord.
• The only serviceable item is the impellor set. The
motor unit of the pump is encapsulated with epoxy
resin and does not need lubrication.
• All AQUAPRO submersible pumps are water
cooled; if pump becomes restricted it will overheat
and could cause permanent damage. Ensure pump
does not become blocked or restricted.
• The power cord cannot be replaced. If the cord is
damaged, the pump must be discarded.
• The impellor set is a wearing consumable part.
Regular inspections, cleaning and maintenance of
impellor is necessary to ensure longer impellor life. If
the impellor set becomes worn or damaged it should
be replaced (available from your dealer or special
orders). Failure to do so may cause serious damage
to pump.
PART DESCRIPTION
1. FRONT CAGE 2. IMPELLOR COVER 3. IMPELLOR
4. HOSE CONNECTOR 5. MOTOR
1
AP550 IMAGE SHOWN FOR ILLUSTRATION PURPOSES ONLY
S@AQUAPROONLINE.COM.AU
AQUAPRO AP200LV/AP210/AP550/AP750LV Instructions.indd 3
AQUAPRO AP200LV/AP210/AP550/AP750LV Instructions.indd 3
WATER FEATURE PUMP
4
2
3
WWW.AQUAPROONLINE.COM.AU
WEB
I N S T R U C T I O N S
1. Disconnect the power cord from the power supply
before performing maintenance.
2. Remove from water, detach tubing/ fountain kit and
remove front cage from pump.
3. Remove the impellor cover by either turning anti-
clockwise and pulling out or pulling tab to unclip
(depending on model).
4. Gently remove the impellor and shaft, use long nose
pliers if needed. Take care not to break ceramic shaft
(if applicable) because they are brittle.
5. Clean impellor, checking for any signs of wear or
damage.
6. Reinstall the shaft, and then carefully slide the
impellor onto the shaft. The impellor will pull itself in
by magnetic force, this is normal (take care not to
pinch your fingers).
7. Replace the impellor cover making sure the shaft is
located properly on the impellor cover.
8. Replace the front cage.
9. Re-attach tubing/fountain kit, submerse in water,
connect to power supply and turn on.
NOTE:
PLEASE CONSULT YOUR RETAILER
FOR QUALITY ORIGINAL AQUAPRO
REPLACEMENT PARTS FOR YOUR
AQUAPRO PRODUCT.
VISIT WWW.AQUAPROONLINE.COM.AU FOR
NEAREST STOCKISTS.
5
2/5/2022 11:32 am
2/5/2022 11:32 am