Diamond IE140/R9 Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Refrigerator Diamond IE140/R9. Diamond IE140/R9 9 pages. Refrigerated cabinets

Print Page

Remove the pallet, taking care not to knock the unit. The cabinet can now be levelled, screwing in or

unscrewing the legs. When it is levelled, the protection film can be removed from the stainless steel

using a blunt object, and not a cutter as it could scratch the steel.

There must be a gap of 50 mm at the back and 30 mm at the sides of the cabinet when it has been

permanently installed.

1.1 CLEANING

Now that our cabinet is correctly installed, we must proceed to cleaning it:

The first cleaning must be carried out with water and neutral detergent. Once clean and dry, insert

the accessories in the appropriate places, as you prefer.

We recommend cleaning the outside of the unit daily with a damp cloth and following the direction of

the stainless steel's polished finish. Abrasive substances or those containing chlorine must not be

used. Rinse with clean water, avoiding direct water jets.

CONNECTION

1.2 GENERAL

Before connecting the cabinet to the socket, check that the network voltage and frequency correspond

to those indicated on the appliance's nameplate.

It is essential that the electrical installation where the cabinet is going to be connected has

an EARTHING SOCKET, in addition to the appropriate magneto-thermal switch and

differential protection (we recommend 30 mA)

Check that the section of the electricity socket is appropriate for the consumption it is going to

withstand. It must be a Schuko type socket, as your cabinet's cable is this type (also called F type

and in the EEC 7/4"), with a 4.8 mm terminal and earthing socket.

For your safety, it is prohibited to lengthen this power cable. Do not insert any elements through the

fan guard or refrigerator equipment area grilles. The place where the unit is going to be installed must

be perfectly levelled. In the fish cabinets, the cabinet's drainpipe must be connected to the general

drainage system. This will be carried out according to local regulations.

Turn clockwise to lower the unit

Turn anticlockwise to raise the unit