HP ProCurve 1600M Installation Manual - Page 17

Browse online or download pdf Installation Manual for Switch HP ProCurve 1600M. HP ProCurve 1600M 28 pages. Redundant power supply
Also for HP ProCurve 1600M: Specification Sheet (12 pages), Read Me First (8 pages), Reviewer's Manual (27 pages), Supplementary Manual (2 pages), Supplementary Manual (2 pages), Installation Manual (28 pages), Installation Manual (36 pages), Quick Setup Manual (2 pages), Quick Setup Manual (4 pages), User Manual (8 pages), Manual Supplement (28 pages), Read Me First (16 pages), Installation And Removal (2 pages), Installation Manual (12 pages), Planning And Implementation Manual (40 pages), Product End-Of-Life Disassembly Instructions (2 pages), Installation Manual (46 pages), Diagnostics Manual (2 pages), Disassembly Instructions (2 pages)

Print Page

7. Customize the Port Configuration (Optional)

If the module slot in the Switch 2424M was empty the last time the switch was

either rebooted or reset (or the power to the switch was cycled), then the

module will use preconfigured default parameter values that will work for

most networks.

The default port configuration for the module is:

Ports Enabled: Yes

Mode:

• Gigabit-SX and Gigabit-LX Transceivers — 1000FDx (1000 Mbps, Full

Duplex)

• Gigabit Stacking Transceiver — Auto (auto negotiates flow control if

flow control is enabled for the port)

Trunk (port trunking): None

Switch Mesh: Not a member

Broadcast Limit: 0 (no broadcast limiting)

Flow Control: Disabled

Spanning Tree: Disabled

IGMP: Disabled

Traffic Filters: None (the switch performs its filtering and forwarding

only according to standard address table operation)

If necessary, configure the port(s) in the module by using the switch console

or the web browser interface. For more information, see the Management and

Configuration Guide shipped with the switch, and the online Help provided

in the console and web browser interface.

If the default port configuration listed above is acceptable for your network,

then skip this process.

Installing the Module