Diamond Products CC190PRO Operator's Manual - Page 7
Browse online or download pdf Operator's Manual for Saw Diamond Products CC190PRO. Diamond Products CC190PRO 16 pages. Concrete saw
Print Page
Let the engine cool prior to adding fuel.
Refer to the engine manual for recommended
fuels.
Move the saw away from the refueling area
prior to starting the engine.
Drain the fuel tank and fuel lines when storing
the saw for longer periods of time. Refer to the
engine manual for additional recommendations.
CAUTION
Clean up spilled fuel prior to starting the engine.
If over filled fuel may seep out from the fuel cap
vent when the saw is raised.
WARNING
DO NOT operate the saw with a fuel leak.
DO NOT fuel the saw with the engine
running.
DO NOT smoke or expose fuel to
open flames when filling the fuel
tank and/or working with fuel.
Engine Safety
Refer to the engine manual as the primary
source for engine safety.
Refer to the engine manual for recommended
oil.
Always know how to turn off the engine quickly
for emergency purposes.
Make sure the speed control lever (applicable
models) is at Neutral when starting the engine.
Fill the fuel tank and check the oil level prior to
starting the engine.
Keep all body parts away from
rotating parts with the engine
running.
DO NOT start the engine without the air filter(s)
installed.
DO NOT allow dust to enter the air intake tube
when cleaning/replacing air filter(s).
Immediately replace damaged saw components
that may allow dust to enter the engine.
DO NOT leave the engine/motor running
unattended.
Always operate the saw in well-
ventilated areas. Concentrated
engine exhaust can cause loss of
consciousness and/or death.
DO NOT operate the saw around combustible
materials or fumes to prevent fires/explosions.
DO NOT touch the engine/muffler assembly
with the engine running, and always let them
cool down prior to touching or servicing the
saw.
Handle hot oil carefully when changing the oil.
DO NOT spray the engine/motor with water to
prevent engine/motor damage.
Let the engine cool prior to
removing pressurized caps
(applicable models).
DO NOT use any starter substances or starter
fluids (e.g., starter fluid sprayed into the air
filter) when starting the engine using a glow
plug (applicable models). These materials are
extremely flammable and explosive, and can
melt parts or possibly explode when used to
help start the engine.
Stopping the Engine
CAUTION
DO NOT leave the saw unattended until the
engine is off and the blade has stopped
spinning.
Cutting Safety
The direct work area should not contain buried
or embedded electrical, gas, or water lines that
could be damaged and/or cause personal injury
while cutting.
Turn off all electricity, gas, and water around
the direct work area prior to cutting.
DO NOT expose yourself or
anyone else to the direct line of
the blade when operating the
saw.
DO NOT allow any person, animal, and/or
object in and around the work area while
cutting.
DO NOT assume the saw will remain still while
in Neutral when stopping and/or parking the
saw on a slope. Chock the wheels to prevent
unnecessary movement.
7